Orlando homes lose fascia boards when afternoon thunderstorms dump heavy rain and wind against the eaves. Wood fascia on 1970s and 1980s stock often rots at the joint where the gutter hangs because water sits behind the metal. We cut out the bad sections and sister in pressure-treated pine or switch to aluminum to stop the cycle. Orange County requires a permit only when we open more than 25 percent of the roof edge on a single-family house.
Cheap crews skip the drip edge and just nail new fascia over wet sheathing. That mistake shows up two seasons later as streaks down the siding after another round of humid subtropical storms. We always pull the old drip edge, check the roof underlayment, and install new metal with the correct overhang before the fascia goes back on. This step takes an extra half day but keeps the wall dry.
Soffit panels on single-story homes in Thornton Park and Ivanhoe Village sag when the original vinyl clips fail. We replace them with aluminum vented panels that match the existing color and add extra screws into the rafter tails. The job usually finishes in one day once the fascia is solid. We leave the site clean and walk the homeowner through the new vents so they know where airflow comes from.
Call 407-555-0199 for 24/7 emergency soffit and fascia repair. We answer day or night and can be on site in Downtown Orlando or Winter Park within a few hours when wind has torn panels loose.
Soffit and Fascia Repair Services We Offer
✓Emergency Soffit Repair Orlando
Same-day fix for wind-torn or fallen soffit panels after storms, using aluminum vented material on homes in Baldwin Park.
✓Fascia Board Replacement
Cut out rotted wood fascia and install new aluminum or treated pine on single-story houses in Mills 50 and College Park.
✓Soffit and Fascia Repair After Storm
Inspect and replace damaged sections on homes near Lake Eola Park, done in one day with matching materials.
✓Commercial Soffit Repair
Fix sagging soffit on small commercial buildings in Orange County using heavy-gauge aluminum and extra fasteners.
✓Soffit Vent Replacement
Swap failed vinyl soffit vents for aluminum on homes in Winter Park to restore attic airflow in under four hours.
Soffit and Fascia Repair Cost in Orlando, FL
| Service | Typical Range | What Affects It |
|---|---|---|
| Replace fascia on single story home | $1,200–$2,400 | Price rises with wood versus aluminum and total linear feet. |
| Soffit and fascia repair after storm | $1,800–$3,500 | Depends on how many sections are torn and whether rafter tails need sistering. |
| Commercial soffit repair | $2,500–$5,000 | Higher gauge material and longer runs increase cost. |
| Soffit vent replacement only | $600–$1,100 | Lower when fascia stays in place and access is easy. |
| Free estimate and inspection | Free | Call 407-555-0199 or stop by 1271 La Quinta Dr, Orlando, FL 32809. Mon-Sat 7am-7pm, 24/7 emergency. |
Ranges are typical for Orlando, FL and confirmed with an exact written quote before any work starts.
How it works
- 1
Site Walk And Photos
We check every foot of soffit and fascia, note rot, loose nails, and missing vents, then send photos same hour. Takes 30 to 45 minutes.
- 2
Material Pull And Permit
Order aluminum or wood, pull any needed Orange County permit, and stage on site. Usually one day lead time.
- 3
Demo And Repair
Remove damaged sections, sister rafter tails if needed, install new drip edge and fascia. One to two days on most homes.
- 4
Soffit Install And Clean
Hang new vented soffit, secure all clips, caulk joints, and haul debris. Finish same day as fascia work.
Pricing
Most soffit and fascia jobs in Orlando land between $1,200 and $3,800. Access on two-story homes or extensive rot pushes the upper end.